RZR Weld In Frame Repair Washer 10mm
Installation is relatively simple. First you drill out the damaged existing pivot hole to 1”. After you clean up the burrs, the washer is tacked in place and fully welded. We recommend using a Unibit style drill bit to drill out the a-arm pivot mounts to 1”, this will keep the hole centered and round. The washers are made thin enough to not require a new bolt for assembly. You should, though, check that the condition of your hardware is good enough to use.
- Item Requires Shipping
- 0.1 lbs.
Total Reviews (0)
Write the First Review!
You must login to post a review.